As another week rolled off the calendar with highs in the 70s and low 80s, it becomes more apparent that this late summer and fall won't be a repeat of last year. Looking like corn was headed for high-moisture harvest a year ago, a warm August and September, plus a very late killing frost bailed out the crop for most people. This year, however, the temperatures seem content to run about average or slightly below for this time of year, and future weather reports say to expect a normal or slightly earlier frost than normal.
That would mean wet corn to handle in Indiana. "I'm looking hard at buying a second dryer, and I know neighbors who are doing the same thing," a farmer remarked at the Farm Progress show last week. He's already decided his crop will be wet, and is looking for ways to increase drying capacity so he won't have to slow down harvest capacity.
Resigning to the fact that you won't be able to run full-blown on harvest capacity, but instead will need to allow time to dry corn is another option. Richard Stroshine, Purdue grain specialist. Here are his observations.
"It's going to start in the field," he says. "If farmers must run corn wetter than 25% moisture, they're likely to see more seed coats scratched and cut," he says. The kernel is simply more tender at that point.
"While it may not seem like a big deal at the time, it will make corn harder to store alter on, especially if you need to carry it into winter, damaged kernels will be more subject to infection."
At that point the decision is to weigh running vs. leave the crop in the field, risk field losses later, and risk damaging corn and losing yield by leaving it in the field too long. If you decide to start early, even if corn is around 30 % moisture, pay attention to combine settings, Stroshine says.
"Do whatever you can to minimize damage," he offers. "Experiment with concave settings and find one you can live with that does minimal damage to corn," he notes.
"Slow down the machine as much as you can. The whole idea is to put corn in the grain tank with as few of fines as possible."
A grain cleaner to take out those fines before corn enters the bin will also be helpful, he says.
As for storage, here's one idea to consider if you want to maintain harvest capacity as much as possible. Stroshine suggests knocking the top 6 to points off in the dryer. That assumes corn is 25% or above in the beginning. Then you can hold it for a while longer until you can get back to dry it.
You can hold corn considerable longer at 20% moisture than at 30%. Of course, this will take careful management to make sure the corn you've partially dried doesn't go out of condition until you can find time to dry it, he concluded.