Sponsored By
indiana Prairie Farmer Logo

Tips for Pulling Soil SamplesTips for Pulling Soil Samples

Fall key time of year to pull soil samples.

Tom Bechman 1

October 3, 2011

2 Min Read

One year ago, it was so dry that some postponed taking soil samples. Some that were taken produced results that were suspect due to the dry conditions. So besides the normal rotation of fields that you test every third year, every other year or every year, depending on how intense your soil sampling program is, you may have acres from last year that you want to test again this year.

You may do your own testing or hire a soils consultant to test for you. Either way, it's important to understand what goes into getting a good soil test that provides reliable results. That should give you more confidence in making and following recommendations for applying fertilizer based upon those tests.

Instead of being too dry, if rains continue or if late fall turns wet as some predict, the problem this fall could be finding a time when soils are dry enough to get a good test. Remember that if you normally test in the fall, test results will be most accurate if you always test in the fall, rather than taking some tests in the fall and some in the spring.

Here are tips offered by Purdue University agronomists. You can find more about soil sampling in the Purdue university Corn and Soybean Field Guide, 2011 edition, on pages 174-175.

Take 20 to 30 cores with a probe to form one sample. Mix all cores together and pull a sample from the entire set of cores.

While one sample can represent 20 acres, it's customary to divide that into smaller areas to sample today. The less uniform the ground, the smaller the areas you may want one sample to represent.

If fertilizer is banded when applied, take more cores than you would fi fertilizer was broadcast across the field.

Take soil samples to 8 inches deep in tilled fields. It's important to make sure you sample at exactly the same depth each time. Many consultants mark probes so they're getting the same depth each time.

In long-term no-till fields, you may want to sample at 0-4 inches and 4-8 inches separately. Certain factors, such as pH, tend to change faster and closer to the surface in no-till systems.

Sample lighter soils or sandy soils more often, say every one to two years even if you typically sample average soils every three years. These soils have lower nutrient holding capacity.

About the Author(s)

Tom Bechman 1

Editor, Indiana Prairie Farm

Tom Bechman is an important cog in the Farm Progress machinery. In addition to serving as editor of Indiana Prairie Farmer, Tom is nationally known for his coverage of Midwest agronomy, conservation, no-till farming, farm management, farm safety, high-tech farming and personal property tax relief. His byline appears monthly in many of the 18 state and regional farm magazines published by Farm Progress.

"I consider it my responsibility and opportunity as a farm magazine editor to supply useful information that will help today's farm families survive and thrive," the veteran editor says.

Tom graduated from Whiteland (Ind.) High School, earned his B.S. in animal science and agricultural education from Purdue University in 1975 and an M.S. in dairy nutrition two years later. He first joined the magazine as a field editor in 1981 after four years as a vocational agriculture teacher.

Tom enjoys interacting with farm families, university specialists and industry leaders, gathering and sifting through loads of information available in agriculture today. "Whenever I find a new idea or a new thought that could either improve someone's life or their income, I consider it a personal challenge to discover how to present it in the most useful form, " he says.

Subscribe to receive top agriculture news
Be informed daily with these free e-newsletters

You May Also Like