Wallaces Farmer

A look at cover crop seeding methods

Cover crops can be planted in many ways — each has advantages and limitations.

August 2, 2019

3 Min Read
seeder equipment
SUCCESSFUL SEEDING: The key is to find the planting or seeding method best suited for your farming operation’s cover crop goals.

If you want to plant cover crops in the fall, it pays to plan ahead. Cover crop species, seeding method, seeding rate and timing will all depend on the goals you have for that cover crop.

In broad terms, there are three seeding methods: overseeding, drill seeding and broadcast seeding with incorporation. Each of these methods has pros and cons, says Mark Licht, Iowa State University Extension cropping systems agronomist.

He offers the following observations and recommendations to help you increase the odds that your cover crop seeding will be successful.

Overseeding. Overseeding can be done into a standing corn or soybean crop either by broadcasting with an airplane or using high clearance equipment. Overseeding allows the cover crop to be planted earlier, which can lead to greater biomass growth in the fall. However, overseeding does have some drawbacks.

For one, distribution of seed can be more variable with aerial seeding. The best distribution comes from uniform seed lots and heavier cereal grain, such as cereal rye and winter wheat. Also, stand establishment can be lower than with other seeding options due to rodents and birds scavenging seed, as well as if dry conditions exist following seeding.

To ensure adequate establishment, overseeding should be done from late August to early September, assuming adequate soil moisture. Some of the most successful overseedings are done shortly before a rainfall. The seeding rate for overseeding should be 15% to 25% higher than drill seeding.

Drilling. Drill seeding provides the most uniform seed distribution and excellent seed-to-soil contact for establishment, which results in a more consistent stand. One of the biggest drawbacks of drill seeding is that corn and soybean harvest can delay cover crop planting beyond ideal planting dates. Delayed planting can result in reduced biomass growth and less nitrogen uptake. Drill seeding should be completed by mid- to late October.

Broadcasting with incorporation. Broadcast seeding with incorporation after corn and soybean harvest is also a viable option to plant cover crops. It can be accomplished as a one- or two-pass process. One-pass systems typically have an air seeder attached to the combine or broadcast cover crop seed with fertilizer application. Incorporation can be accomplished with vertical tillage or other tillage implements, but care must be taken to ensure that incorporation is not too deep for plant emergence.

Broadcast seeding with incorporation can improve overall stand establishment compared to broadcast seeding without incorporation. Like drill seeding, broadcast seeding with incorporation should be completed by mid-to-late October.

For more information on cover crop species and cover crop management visit:

Source: ISU, which is responsible for information provided and is wholly owned by source. Informa Business Media and subsidiaries aren’t responsible for any content in this information asset.

 

 

 

Subscribe to receive top agriculture news
Be informed daily with these free e-newsletters

You May Also Like